Grand Am Rear Speakers How Do You Remove The Rear Speakers From A 200 Pontiac Grand Am.?
How do you remove the rear speakers from a 200 pontiac grand am.? - grand am rear speakers
Im not sure if forceps or what I do not want to break. There is so much breath and bought new ones. I think we should run through the fuselage, but I'm not 100% sure.
Thanks
|
7 comments:
I have a wing, the same thing, put the back seat. There is a sheet of plastic with a few things out of plastic in the celebration. You should be able to go into retirement with his fingers. with the advance on the cover that goes speakers. Speaker in a plastic, which is reflected in the metal form, have 2 clips on each side and just make sure you pull the speaker cables. May pushed a little hard on the break, after receiving the speaker not to, but
Radio Rear Speaker Replacement
Remove
They have removed the control panel back yard. Look at the platform rear window replacement trim panel linings.
The foam sound insulation, remove the rear platform.
Clear Sheet holding back speakers.
Remove the rear speakers on the rear platform.
Disconnect the electrical connection of speakers.
Installation Procedure
Connect the power cable for the rear speakers.
Place the enclosure behind the rear platform.
Install the rear speakers. Make sure that the plastic tabs can he rear platform.
Install sound insulating foam on the rear platform.
Install the rear deck panel of the court. Contact the trim panel platform sedanthe replacement liner.
Rear Window Trim Panel Replacement Platform
Remove
Tools Required
J 38,778 Door Trim Pad and Garnish Clip Remover
Remove the rear seat. Refer to the rear seat cushion replacement in the seats.
Remove the rear seat. Refer back to the back seat replacement - to the place.
The bottom quarter of the removal court. See Trim replacement lower rear quarter panel.
Remove the quarter ended higher. See Trim upper rear quarter panel replacement.
Remove rear seat belts T-slots in the rear window and cut.
Remove the rear trim panel garnish thrust anchor with J 38,778 Door Trim Pad and Clip Remover.
Remove the window and checkSlide the cover out.
Installation Procedure
Push to install the rear window design aperture.
Install the windows and a setback cut through the installation of seat belts in the T-slots in the rear window.
Install push the mandate for the rear window glass of the plate.
Install the quarter ended higher. See Trim upper rear quarter panel replacement.
Install the lower quarter of the court. See Trim replacement lower rear quarter panel.
Install the rear seat. Refer back to the back seat replacement - to the place.
Install the rear seat cushion. Refer to the rear seat cushion replacement in the seats.
If they are blown to break, why not? And yes, go through the trunk.
Refer to the manual that you what to do. Typically, you only need a screwdriver. Replacing the speaker is a fairly simple task.
Buy Screwdriver
If the only thing worthwhile
You have to remove the rear cover. The speakers do not come through the hull. I had the parts inside the post to delete it, goes into the rear window, which complement and easy to remove. Under the rear seats and remove the plastic holding the front of the ramp back, there are 5 plastic washers. After slipping these three pieces are drawn from the stack. The speakers are the place with two retaining clips on each speaker. Once the list of speakers to remove the plastic ring that snaps that kept the speakers in the vehicle. I found that the detention should be in the 6X9 speakers in line. I installed the first set, and he hated her, and I'm in a new outfit. Any replacement can be done a little more than an hour.
Post a Comment